The fermentation heating belt is a handy brewing gadget that will raise the temperature of your primary fermentation bucket about 10 degrees above room temperature. Typically this heater belt will maintain a temperature of 75-80° F (23-27°C). Most air-conditioned homes are too cool, and the Brew Belt is the perfect solution when you need a little extra heat to keep your fermentation warm enough. This simple belt unit produces 25 watts of heat right where you want it. Instead of having to raise the temperature of the room or find a warm spot, just attach the Brew Belt, plug it in, and the temperature will be perfectly maintained for a rapid and complete fermentation.
Brewing Heater Belt can be customized as client’s requirement,Our standard specs as below:
1.belt width have 14mm and 20mm;
2. Voltage can be made from 110V to 240V
3. belt length is 900mm and the power line length is 1900mm
4. The plug can be customized USA plug,UK plug,Euro plug and so on.
The normal laying power is 100-160 watts per square. Different areas can be increased or decreased according to the room's own insulation and the type of floor. The installation is very simple, we will guide the installation, the normal laying distance is 12cm.
During installation, the carbon fiber heating wires must not touch one other or cross over one another. After installation, wait until the concrete floor is completely dry before heating it to avoid the risk of the floor cracking or twisting as a result of an extreme temperature rise. Setting the minimum temperature first, then gradually raising the temperature is advised when using the floor heating for an extended period of time.
Cross-over will make the heating line local temperature higher than the melting point of the protective layer, will damage the heating wire!
Cold wire and hot wire make up the heating cable's inner core. An insulating layer, a grounding layer, a shielding layer, and an outer jacket make up the outer core. The hot wire heats up and reaches temperatures between 40 and 60 degrees Celsius after the heating cable is powered on. The heating wire, which is incorporated into the filler layer, emits far-infrared radiation between the wavelengths of 8 and 13 m and transmits heat energy through convection (heat conduction).
1. Road snow melting
2. Pipe insulation
3. Soil heating system
4. Roofing melting snow and melting ice
