When the silicone rubber heating bed is plugged in, the electric heating wire assembly can raise the temperature to the rated value in a very short time, and after the installation of insulation, it has a very practical temperature control effect. However, in the whole heating process, the calorific value consumed by other heating methods is more than the reasonably converted calorific value, which is a clear sign of resources. Therefore, we do not advocate other heating methods.
1. Under adhesive installation conditions, the allowable working temperature of silicone rubber heating mat is lower than 150℃.
2. It should be noted that the operating temperature of silicone rubber heating pad should be lower than 240 ° C, and the gain value should not exceed 300 ° C. Silicone electric heater installation operation is simple, reliable.
3. The choice of working standard voltage is based on high power – high current, low thermal efficiency – low voltage, and the unique silicone rubber heating bed is definitely an exception.
4. If it is burned in the upper air, the heating wire component is limited by the heat resistance of raw materials, and the relative density of silicone rubber heating mat in power engineering should be lower than 1w/cm2; In the non-continuous condition, the power engineering relative density of the silicone heating sheet reaches 1.4W /cm2.
5.silicone rubber heating pad can work under force, that is, the auxiliary pin is used to make it close to the heating surface.
6.silicone rubber heating bed is easy to install and operate, and can be trusted to be used in wet places without combustible gas. It is composed of hydroxide raw materials with good far-infrared radiation source characteristics, and appropriate additives are added to improve the irradiance and improve the adaptability of the billet shaft.
The shell of electric silicone rubber heating pad is deep-drawn by cold-rolled steel plate, and the surface layer is sprayed with electrostatic powder. The heating side uses high-quality structural ceramics, and the temperature setting is automatic temperature control. The data show that it has the advantages of large heating area, rapid heating, temperature balance, accurate temperature control and cost saving. Heating side selection of high-quality structural ceramics, corrosion resistance, anti-aging, durable and reliable.
Post time: Oct-09-2024