| Material | Silicone Rubber |
| Temperature Range | 0-120 Degree |
| Voltage | 220V |
| Power | 100W-1000W |
| Lead Length | 300mm |
| Width | 15mm/ 20mm/ 25mm/ 30mm/ 50mm |
| Length | 1m to 10m |
| Thermostat | Digital available |
1. Nickel and chromium alloy wire and insulating materials make up the majority of the product. It heats up quickly, is highly thermally efficient, and has a long lifespan.
2. Silicon rubber, which has strong heat resistance and consistent insulation performance, serves as the primary insulation.
3. The item is adaptable and can be wrapped directly around the heater. It heats evenly and makes good contact.
4. Material Optimization: Consists primarily of nickel and chromium alloy wire and insulating material, which are quick to heat up, have good thermal efficiency, and have a long useful life.
5.Easy Installation: It can be installed by wrapping it directly over the hot part's surface.
1. Operating conditions
The ambient temperature is -30~180* C
Relative humidity is 30%~90%
The power supply is 220V Shi 15% 50HZ
2. Appearance and external dimensions
Tropical surface should be smooth, uniform color, no obvious scars and porosity, the appearance of the size should be in line with the user's design requirements.
3 tropical heating wire and the lead wire should be able to withstand 30N tension after 30S without disengagement and displacement phenomenon.
4. The resistance value of tropicalization does not exceed 7% of the specified resistance value of the earth.
5. Tropical heating body in the same area of the work temperature uniformity, its distribution deviation is not greater than 10%.
6. Tropicalized immersed in water after 24h, should be able to withstand 1500V ephemeral 1min or 2000V, 1S dielectric strength test, no breakdown or flashover phenomenon
7. Tropicalized in water after 24h, its insulation resistance should be greater than 200M ?
8. Tropical immersion in water leakage current should be no more than 0.2mA.
9. Tropical in the temperature -30 * C or 180C high and low temperature test, test time for 72h, should not appear any cracks, deformation or other damage to the function of the tropical, and should be in line with the requirements of 4.7 and 4.8.
10. heating tape in the temperature 40 * C, relative humidity 90 ~ 95%, time 48h limit conditions after the test, there should be no deformation, cracks, damage and other phenomena, and should be in line with the requirements of 4.7 and 4.8.
11. heating tape should be able to withstand the rated power 1.33 times the work cycle of 5 cycles of overload test, there shall be no deformation, rupture and other serious impact on the performance of heating tape damage phenomenon.
12. heating tape to withstand the rated voltage 1.15 times the continuous power not less than 72h aging test, the surface does not oxidation cracking phenomenon, and can work normally.
