Whirlpool W10703867 Dishwasher Heater Element

Short Description:

The W10703867 dishwasher heater element designed to monitor and control water heat during the dishwashing cycles and helps dry the dishes at the end of the cycle.If your Dishwasher doesn’t dry the dishes carefully, the water is too hot/too cold, in case of starting failure, leaks, or the cleaning light blinks on the control panel, you need to replace W10703867 whirlpool dishwasher heating element.

Send email to us

Product Detail

Product Tags

Product Paramenters

Porduct Name	Whirlpool W10703867 Dishwasher Heater Element
Humidity State Insulation Resistance	≥200MΩ
After Humid Heat Test Insulation Resistance	≥30MΩ
Humidity State Leakage Current	≤0.1mA
Surface Load	≤3.5W/cm2
Tube diameter	8.0mm
Tube material	stainless steel 304
Resistant voltage in water	2,000V/min (normal water temperature)
Insulated resistance in water	750MOhm
Use	Dishwasher Heating Element
Package	one heater with one bag,35pcs per carton
Certification	CE/CQC
The W10703867 dishwasher heater element designed to monitor and control water heat during the dishwashing cycles and helps dry the dishes at the end of the cycle.If your Dishwasher doesn’t dry the dishes carefully, the water is too hot/too cold, in case of starting failure, leaks,or the cleaning light blinks on the control panel,you need to replace W10703867 whirlpool dishwasher heating element. 1. Package includes: 1 x W10703867 Dishwasher Heater Element,2 x composite plastic nuts heater fasteners. ---This W10703867 whirlpool dishwasher heating element is made of durable,heat-resistant high-quality stainless steel 304 tube,the whirlpool dishwasher heating element can withstand high temperature and produce uniform heat. ---Equipped with composite plastic nuts and form a Insulated connection after installation,protecting the heating element tip from being bent and compressed.

Defrost Heater

Aluminum Foil Heater

Drain Line Heater

Product Installation

1. Be sure to disconnect the power and water supply before installation,Remove lower access panel,remove cover from power junction box,remove wire nuts and separate wires.

2. Remove water supply line.

3. Slide dryer out of under cabinet so rear can be accessed.Remove electrical connectors from ends of heater coil.

4. Use adjustable wrench to remove plastic nuts from ends of heater coil.The heater coil should be to remove.

5. Reverse dis-assembly for installing new heater coil.